LifeSource UA-851 Instruction Manual page 11

2. Lay left arm on the table, palm up and thread cuff
end through metal loop, smooth size against arm.
Then position the tube off-center toward the inner
side of arm in line with the little finger.
3. Secure cuff around arm. The cuff should be
snug but not too tight. You should be able to
insert two fingers between the cuff and your
arm.
4. Confirm that the Index Mark
5. Press the START button. As the cuff pressurizes, measurement will begin
and the Cuff Inflation Meter will show on the display screen. It is normal
for the cuff to feel very tight.
Note: If an appropriate pressure is not obtained, the device automatically starts
to inflate again.
Note: If you wish to stop inflation at any time, press the START button again.
6. When the measurement is complete, the systolic and diastolic pressure
readings and pulse rate are displayed. The cuff deflates and the monitor
automatically shuts off after 60 seconds, or you can turn it off by pressing
the START button. Your measurement is automatically stored in memory
(the monitor can store up to 90 readings in memory).
7. Remove cuff and make note of your blood pressure and pulse rate in the
Blood Pressure Logbook, indicating the date and time of measurement.
IMPORTANT: Measure blood pressure at the same time each day.
LifeSource Health Line (Toll-Free): 1-888-726-9966
TAKING YOUR BLOOD PRESSURE
points within the proper fit range.
SYSTOLIC
DIASTOLIC
PULSE
E-7