Grizzly G0637 Owner's Manual page 51

6.
With help from another person to steady the
canister assembly, turn it upside down and
remove the two M8-1.25 x 20mm hex bolts,
hex nuts, and flat washers from the cross
support (see figure 91), then remove the
canister base from the assembly.
remove these
figure 91. Cross support fasteners.
7.
Carefully lift the filter from the canister assem-
bly, as shown in figure 92.
figure 92. removing the filter from the canister
assembly.
Model G0637/G0638 (Mfg. Since 04/12)
8.
Before re-inserting a filter into the assembly,
make sure that the filter brush base is aligned
with two of the fastener holes around the
base of the assembly (see figure 93). this
will allow the canister base to align with the
fastener holes around the brush base.
figure 93. Filter brush base aligned with
assembly fastener holes.
9. re-insert a filter into the canister assembly.
note: Make sure the bristles of the brush are
straight to ensure efficient cleaning of the
filter when needed.
10. re-attach the canister base in the reverse
order that you removed it.
11. re-attach the canister assembly to the dust
collector, then re-install a fresh collection bag
with the bag clamp.
-49-