Grizzly G0637 Owner's Manual page 26

13. install the four cyclone mounting brackets
with (8) 3 ⁄ "-16 x 1
8
flat washers, and (8)
figures 22 & 24).
figure 24. Cyclone mounting bracket mounted
to collector assembly.
14. Apply the 3 x 6 x 2500mm gasket to the top
mating surface of the intake barrel assembly.
15. Keeping the intake barrel assembly on the
floor, lower the blower housing assembly
over and approximately one inch away from
the intake barrel assembly.
16. using two punches or phillips screwdrivers
as alignment guides (see figure 25), lower
the blower housing assembly onto the intake
barrel assembly.
outlet
port
figure 25. Aligning the mounting holes.
-24-
1 ⁄ " hex bolts, (16) 3 ⁄
4 8
⁄ "-16 lock nuts (see
3
8
note: Orient the two assemblies so that the
" large, round intake port of the intake barrel
is NOT directly underneath the rectangular
outlet port of the blower housing. The outlet
port will connect to the canister filters and will
not allow room for attachment of the intake
ducting to the intake port.
17. Attach the two assemblies with the (12)
18 x ⁄ " hex bolts and (12)
3
4
(see figure 26).
figure 26. securing intake barrel assembly to
blower housing assembly.
tip: When installing the two bolts above the
intake port of the intake barrel, use duct tape
on the bottom of your wrench. This will hold
the bolts in the wrench while inserting them in
place (see Figure 27).
figure 27. using tape on a wrench in a tight
Model G0637/G0638 (Mfg. Since 04/12)
5
⁄ " flat washers
5
16
spot.
⁄ "-
16