Static Routing-Track-Bfd Collaboration Configuration Example - HP 6125XLG Configuration Manual

Static routing-Track-BFD collaboration configuration example

Network requirements
As shown in
30.1.1.0/24. Configure static routes on these routers so that the two segments can communicate with
each other. Configure route backup to improve network reliability.
Switch A is the default gateway of the hosts in segment 20.1.1.0/24. Two static routes to 30.1.1.0/24 exist
on Switch A, with the next hop being Switch B and Switch C, respectively. These two static routes back
up each other as follows:
The static route with Switch B as the next hop has a higher priority and is the master route. If this
•
route is available, Switch A forwards packets to 30.1.1.0/24 through Switch B.
The static route with Switch C as the next hop acts as the backup route.
•
Configure static routing-Track-BFD collaboration to determine whether the master route is available
•
in real time. If the master route is unavailable, BFD can quickly detect the route failure to make the
backup route take effect, and Switch A forwards packets to 30.1.1.0/24 through Switch C and
Switch B.
Similarly, Switch B is the default gateway of the hosts in segment 30.1.1.0/24. Two static routes to
20.1.1.0/24 exist on Switch B, with the next hop being Switch A and Switch C, respectively. These two
static routes back up each other as follows:
The static route with Switch A as the next hop has a higher priority and is the master route. If this
•
route is available, Switch B forwards packets to 20.1.1.0/24 through Switch A.
• The static route with Switch C as the next hop acts as the backup route.
Configure static routing-Track-BFD collaboration to determine whether the master route is available
•
in real time. If the master route is unavailable, BFD can quickly detect the route failure to make the
backup route take effect, and Switch B forwards packets to 20.1.1.0/24 through Switch C and
Switch A.
Figure 31 Network diagram
Configuration procedure
1. Create VLANs and assign corresponding ports to them. Configure the IP address of each VLAN
interface as shown in
2. Configure Switch A:
# Configure a static route to 30.1.1.0/24, with the address of the next hop as 10.2.1.2 and the
default priority 60. This static route is associated with track entry 1.
<SwitchA> system-view
Figure 31, Switch A, Switch B, and Switch C are connected to two segments 20.1.1.0/24 and
Figure 31. (Details not shown.)
117