Configuring Vrrp; Overview - HP 6125XLG Configuration Manual

Blade switch high availability configuration guide
Table of Contents

Advertisement

Configuring VRRP

The interfaces that VRRP involves can be only Layer 3 Ethernet interfaces and VLAN interfaces unless
otherwise specified. You can configure an Ethernet port as a Layer 3 interface by using the port
link-mode route command (see Layer 2—LAN Switching Configuration Guide).

Overview

Typically, you can configure a default gateway for every host on a LAN. All packets destined for other
networks are sent through the default gateway. As shown in
no hosts can communicate with external networks.
Figure 12 LAN networking
Using a default gateway facilitates your configuration but requires high availability. Using more egress
gateways improves link availability but introduces the problem of routing among the egresses.
Virtual Router Redundancy Protocol (VRRP) is designed to address this issue. VRRP adds a group of
network gateways to a VRRP group called a "virtual router." A VRRP group comprises one master and
multiple backups, but has only one virtual IP address. The hosts on the subnet only need to configure this
virtual IP address as their default network gateway for communicating with external networks.
The virtual IP address of the virtual router can be either an unused IP address on the subnet where the
VRRP group resides or the IP address of an interface on a router in the VRRP group. In the latter case, the
router is called the IP address owner. A VRRP group can have only one IP address owner.
VRRP avoids single points of failure and simplifies the configuration on hosts. When the master in the
VRRP group on a multicast or broadcast LAN (for example, an Ethernet network) fails, another router in
the VRRP group can take over as the master without causing dynamic route recalculation, route
re-discovery, gateway reconfiguration on the hosts, or traffic interruption.
VRRP operates in either of the following modes:
Standard mode—Implemented based on RFCs. For more information, see
Figure
40
12, when the default gateway fails,
"VRRP standard
mode."

Advertisement

Table of Contents
loading

Table of Contents