Vrrp Load Balancing Configuration Example - HP 6125XLG Configuration Manual

Config Pri
Preempt Mode
Auth Type
Virtual IP
Master IP
Interface Vlan-interface3
VRID
Admin Status
Config Pri
Preempt Mode
Auth Type
Virtual IP
Virtual MAC
Master IP
The output shows that Switch A is operating as the master in VRRP group 1 to forward Internet
traffic for hosts that use the default gateway 10.1.1.100/25, and Switch B is operating as the
master in VRRP group 2 to forward Internet traffic for hosts that use the default gateway
10.1.1.200/25.

VRRP load balancing configuration example

This section provides an example of configuring the VRRP load balancing mode.
Network requirements
Switch A, Switch B, and Switch C form a load-balanced VRRP group and use the virtual IP address
10.1.1.1/24 to provide gateway service for subnet 10.1.1.0/24, as shown in
Configure VFs on Switch A, Switch B, and Switch C to monitor their respective VLAN-interface 3. When
the interface on any one of them fails, the weights of the VFs on the problematic switch decrease so
another AVF can take over.
: 100
: Yes
: None
: 10.1.1.100
: 10.1.1.1
: 2
: Up
: 110
: Yes
: None
: 10.1.1.200
: 0000-5e00-0102
: 10.1.1.131
64
Running Pri : 100
Delay Time : 0
Adver Timer : 100
State : Master
Running Pri : 110
Delay Time : 0
Figure 22.