Using The Optional Usb Floppy Disk Drive - Toshiba TECRA S4 User Manual

Operating Basics
■
Avoid swiping with the finger stiff or pressed-on too hard
Fingerprint reading may fail if the center of the fingerprint is not
touching on the sensor, or when finger is swiped while pressing hard.
Make sure that the center of the fingerprint is touching the sensor
before swiping.
■
Confirm the center of the fingerprint whirl before swiping
Always confirm the center of the fingerprint whirl so that it is swiped
along the center line of the sensor.
■
When fingerprint reading is not successful
There is a possibility of authentication failures if the finger is swiped too
quickly or too slowly. Follow the onscreen instructions to adjust the
speed of the swipe.

Using the optional USB floppy disk drive

The USB floppy disk drive accommodates 1.44-megabyte or 720-kilobyte
floppy disks and connects to a USB port. Refer to Chapter 2,
Tour, for more information.
Connecting USB floppy disk drive
To connect the drive, plug the floppy disk drive's USB connector into a
computer's USB port. Refer to the following figure.
Make sure the connector is back side up and properly aligned with the
socket. Do not try to force the connection, doing so can damage the
connecting pins.
If you connect the USB floppy disk drive after turning on the computer, it
will take about 10 seconds for the computer to recognize the drive. Do not
disconnect and reconnect before 10 seconds has elapsed.
4-10
USB connector
Connecting the USB floppy disk drive
The Grand
USB port
User's Manual