Yamaha TT-R50E Owner's Manual page 63

camshaft lever, then remove the
cable from the brake camshaft le-
ver.
1. Brake cable
2. Brake camshaft lever
3. Brake lever free play adjusting nut
3. Loosen the axle nut.
1. Axle nut
2. Washer
PERIODIC MAINTENANCE AND MINOR REPAIR
4. Lift the front wheel off the ground
according to the procedure on
page 6-25.
5. Remove the axle nut and washer.
6. Pull the wheel axle out, and then
remove the wheel.
1. Wheel axle
To install the front wheel
1. Lift the wheel up between the fork
legs.
2. Insert the wheel axle from the
right-hand side.
NOTE:
Make sure that the slot in the brake
shoe plate fits over the retainer on the
fork leg.
6-26
1. Slot
2. Retainer
3. Lower the front wheel so that it is
on the ground.
4. Install the washer and axle nut,
and then tighten the axle nut to the
specified torque.
EAU39801
Tightening torque:
Axle nut:
35 Nm (3.5 m·kgf, 25 ft·lbf)
5. Connect the brake cable to the
brake camshaft lever, and then in-
stall the brake cable free play ad-
justing nut on the brake cable.
6. Adjust the brake lever free play.
(See page 6-14.)
2
1
6