Advertisement
Available languages
Available languages
REMOTE START CONTROL MODULE MOUNTING
8
1. Locate the vehicle's automatic transmission (A / T) module mounted to the
left side of the steering column. (FIGURE V)
2. Route the previously installed windshield mounted antenna harness,
previously installed remote start pre-fit jumper harness and remote start
ignition harness towards the A / T module and plug into the corresponding
connectors on the remote start control module (FIGURE W). Double check
all connectors to ensure a secure fit.
3. Secure the remote start control module to the left side of the A / T module
using the supplied 3M Dual Lock
making sure the remote start ignition harness connector is facing down
(same direction as the A / T module connector). (FIGURE X)
4. As a secondary mounting provision, secure the remote start control module
to the A / T module using the supplied 53cm (21") tie wrap (route the tie wrap
between the 12-pin and 5-pin connectors on the remote start control module
and through the right side of the A / T module bracket). (FIGURE X)
5. Using the supplied 20cm (8") tie wrap, secure excess remote start jumper
harness and antenna harness wiring to the existing vehicle wiring near the
prefit connectors behind the fusebox. (FIGURE Y)
NOTE: After the remote start control module has been mounted and
all wiring secured, operate the tilt / telescopic steering column fully
to ensure that the new components do not interfere with operation
of the tilt / telescopic feature.
PART NUMBER
ISSUE
H001SFJ600
TM
fastener with 2-sided adhesive tape
DATE
00
18 Jul 2013
A/T Module
Ignition Harness
Connector
Tie Wrap
Fuse Box
SUBARU OF AMERICA
Brake Pedal
FIGURE V
Antenna Harness
Jumper Harness
Connector
Connector
FIGURE W
A/T Module
RES Module
FIGURE X
FIGURE Y
8 OF 12
Advertisement
