Subaru H001SFJ600 Installation Instructions Manual page 9

HOOD SAFETY SWITCH MOUNTING
9
1. In the engine compartment, locate the 2-pin pre-fit hood safety switch
connector secured to the ABS unit wire harness with breakaway tape
behind the air filter box on the passenger's side of the vehicle
(FIGURE Z).
2. Mount the hood safety switch bracket to the passenger side inner
fender support using the supplied 10mm bolt and pre-arranged weld
nut in the inner fender support. Torque the mounting bolt to 10.8 Nm
+/- 2 Nm (1.10 Kgf-m +/- 0.2 Kgf-m, 8 ft-lbs +/- 1.5 ft-lbs). The bottom
of the hood safety switch bracket will fit securely against the top of the
plastic fender wire harness grommet. (FIGURE AA)
3. Plug the supplied remote start harness 15cm (6") hood safety switch
wiring harness to the vehicle's 2-pin pre-fit connector. (FIGURE BB)
4. Securely mount (snap-in) the supplied hood safety switch into the
bracket and plug the 15cm (6") hood safety switch wiring harness
female hood switch connector to the base of the hood safety switch.
(FIGURE BB)
5. Using one of the supplied 20cm (8") tie wraps, secure the hood safety
switch wiring harness to the vehicle wire harness. (FIGURE CC)
PART NUMBER ISSUE
H001SFJ600
DATE
18 Jul 2013
00
ABS Unit
Air Box
15cm (6")
Extension
Harness
SUBARU OF AMERICA
Air Box
FIGURE Z
ABS Unit
FIGURE AA
FIGURE BB
Tie Wrap
FIGURE CC
9 OF 12