Replacing The Power-Button Module - Dell Inspiron 660s Owner's Manual

Replacing the Power-Button Module

Procedure
1 Slide the power-button module cable through the slot on the front panel.
2 Align and push the power-button module tabs into the slots on the front
panel.
3 Route the power-button module cable through the routing guides on the
chassis.
4 Connect the power-button module cable to the system-board connector
(LEDH1). See "System Board Components" on page 15.
Postrequisites
1 Replace the drive cage. See "Replacing the Drive Cage" on page 39.
2 Replace the front bezel. See "Replacing the Front Bezel" on page 35.
3 Replace the fan shroud. See "Replacing the Fan Shroud" on page 20.
4 Replace the computer cover. See "Replacing the Computer Cover" on
page 18.
5 Follow the instructions in "After Working Inside Your Computer" on
page 11.
Power Button Module
53