Lexmark MS810n Manual page 2

Plastic containing brominated flame retardants
Asbestos waste and components which contain
asbestos
Cathode ray tubes
Chlorofluorocarbons (CFC), Hydrochlorofluorocarbons
(HCFC) or Hydrofluorocarbons (HFC), Hydrocarbons
(HC)
Gas discharge lamps
Liquid Crystal Display (LCD) greater than 100 cm
those back-lighted with Gas discharge lamps
External electrical cables
Components containing refractory fibres
Components containing radioactive substances
Electrolyte capacitors containing substances of
1
concern
1
With (height > 25 mm, diameter > 25 mm or proportionately similar volume)
Disassembly tools
3.
Item
#2 Phillips screwdriver, magnetic
Wire cutter
E-clip puller or small flat-head screwdriver
Standard slotted head screwdriver
Disassembly references
4.
4.1. Removal procedure(s)
MS710, MS810 WEEE removal
WEEE materials and components removal procedures are available upon request.
Contact: recycling@lexmark.com
4.2. Graphical illustration of material's and component's location
See next page
Doc No.:
3 Fans;
11
Sensors;
8 Fuser
parts
0
0
0
0
2
and 1
1
0
0
4
Rev. 001
Fan(s) and Sensors (locations
illustrated in 4.2)
Plastic parts located in the fuser
assembly marked with recycle code
that includes "FR17"or "FR16"
N/A
N/A
N/A
N/A
MS812de LCD located inside OP
panel
Power cord located on the back lower
left quadrant
N/A
N/A
Capacitor(s) located on Power Supply
(locations illustrated in 4.2)
Page 2 of 17