Optional Accessories; Water Fill - GE Monogram ZBD6400 Owner's Manual

Ge monogram dishwasher owner's manual

Hide thumbs Also See for Monogram ZBD6400:

Installation instructions manual (16 pages)

Owner's manual (32 pages)

Technical service manual (69 pages)

Table Of Contents

Table of Contents

For best performance, check the water fill level of your

Water Fill

dishwasher.

Level

Once the dishwasher is fully connected, run it through a

complete RINSE ONLY cycle to ensure it is emptying and

filling correctly. For low water pressure situations run the

RINSE ONLY cycle 3 times. Halfway through the final

RINSE ONLY cycle, pause the dishwasher and check the

water level inside the dishwasher. If the water level is not

above the minimum water level (marked on the lower

spray support tower), increase the fill level.

1. Ensure the dishwasher is not running through a cycle.

2. Press the START/CANCEL button to select fill time,

3. To test time, press DELAY START. The dishwasher will

4. Once complete, press the WATER TEMP button to

Change the

Dishwasher's

Appearance for

ZBD6400 and

ZBD6500 only

Depress the WATER TEMP button for ten seconds

until the second buzzer sounds (except on ZBD6600

models).

as per chart (65 seconds is the factory setting).

start filling. Listen for the dishwasher to complete

filling. Once filled, the fill level must be checked to

ensure fill time is correct.

exit fill time mode.

You can change the door panel appearance

of your dishwasher by ordering one of these