Figure 3-16. Weather Radar Page - Garmin GTN 6XX System Maintenance Manual

3.4.4.4 Digital Radar Enablement (GTN 7XX Only)
This section describes how to re-enable the Digital Radar
feature, which allows approved ARINC 708 Weather Radars
to be interfaced with the GTN 7XX.
NOTE
For first time Digital Radar enablement, refer to the
GTN 6XX/7XX AML STC IM, P/N 190-01007-A3,
for additional requirements and checkout
procedures. This manual only describes the
necessary steps to re-enable the feature for existing
installations.
1. Turn the GTN off by pulling the NAV/GPS circuit
breaker.
2. Remove the database SD card from the SD card slot
and insert the Digital Radar Enablement Card,
(P/N 010-00878-42), that was used at the initial
installation.
3. Enter configuration mode on the GTN by applying power to the GTN (closing the circuit breaker)
while holding the HOME key.
4. Go to the Weather Radar page from the GTN Options page. Touch the Digital Radar key, as
shown in Figure 3-16.
5. When prompted, touch Yes to enable Digital Weather Radars. When the feature is activated, the
Digital Radar key will be lit green.
NOTE
The feature unlock card should be provided to the customer after service has been
completed.
190-01007-A1
Rev. 5
System Maintenance Manual GTN 6XX/7XX Part 23 AML STC

Figure 3-16. Weather Radar Page

Page 3-15