Table of Contents
Advertisement
Waterproof Connector
Assembling Steps
1. D i s a s s e m b l e t h e c o m p o n e n t s o f t h e
waterproof connector into parts (A) ~ (E) as
shown above. And Hex Nut is including in
the accessory separately.
2. Place the screw nut (E) as shown.
3. F e e d t h e p o w e r c a b l e s t h r o u g h t h e
waterproof connector (F --> E --> D --> B -->
A) as the illustration shows. Then connect
the power cables to the power source. Note:
There are 8 holes on the seal (D), and the
widest holes with a crack on the side are
specific for power cables.
4. If you have external devices such as
sensors and alarms, feed the cables through
Connecting RJ45 Ethernet Cable
RJ45 Cable Dimension (unit: mm)
Recommended cable gauge: 24AWG (0.51 mm)
Assembling Steps:
1
14
14
14
Sealing Nut (A)
Housing (B)
Seals (C)
Seal (D)
Screw Nut (E)
Hex Nut (F)
Gasket
2
the waterproof connector (F --> E --> D --> B
--> A) as previously described. Refer to the
pin definition to connect them to the general
I/O terminal block. Note: The recommended
cable gauge is 2.0 ~ 2.8 mm.
5. Push the seal (D) into the housing (B).
6. Insert the seals (C) into unused holes on the
seal (D) to avoid moisture.
7. Secure the sealing nut (A) tightly and hex nut
(F) from the bottom of the camera.
1. Drill a hole on the supplied gasket
and insert an Ethernet cable through
the opening.
2. Strip part of the sheath from the Eth-
ernet cable.
(A)
(B)
(D)
(E)
(F)
Advertisement
Table of Contents
