Epson PowerLite 260D User Manual page 78

note
The lamp(s) in this
product contain mercury.
Please consult your state and
local regulations regarding
disposal or recycling. Do not
put in the trash.
caution
Do not touch the glass
portion of the lamp assembly.
Touching the glass could
result in premature lamp
failure.
note
Be sure to seat the lamp fully
and secure the lamp cover. If
the lamp is not properly
installed or the cover is loose,
the lamp will not turn on.
Maintenance and Transportation
78
6. Hold the lamp as shown and pull it straight out.
7. Gently insert the new lamp along the guide rail. If it doesn't fit
easily, make sure it's facing the correct way. Push the lamp down
firmly where the label
8. Once the lamp is fully inserted, tighten its screws.
9. Lower the lamp cover into place. (The opening should be almost
covered, and the top of the cover should be flush with the top of
the projector.) Then slide the cover closed and tighten the screw.
10. Reset the lamp timer as described on page 79.
appears.
PUSH