Connecting A Cvbs Signal Source - Epson PowerLite 260D User Manual

Setting Up the Projector
24

Connecting a CVBS Signal Source

If you're connecting a CVBS signal device, use a commercially
available RCA A/V cable. Before starting, make sure the projector and
your image source are turned off.
1. Connect the yellow RCA plug on one end of the cable to the
projector's yellow jack shown below.
PowerLite 260d
PowerLite 280d
2. Connect the yellow plug on the other end of the cable to the
signal-out port on your image source.
3. To play sound through the projector, follow the instructions
beginning on page 28.
If you don't need to make any other connections, you can plug in
your projector and turn it on. See page 31 for instructions.
If more than one device is connected to the projector, select the
correct source after projection starts by pressing the
button on the projector or remote control. See page 33.
Connect yellow RCA
plug on A/V cable
Source Search