HP ProLiant DL320e Specification page 4

QuickSpecs
Standard Features
Storage Controller
One of the following
depending on Model
Internal Storage Devices Diskette Drive
Customer-specific BIOS configuration (using the HP ROM-Based Setup Utility (RBSU).
NOTE: For further information, please refer to HP's RBSU (ROM based setup utility) user guide:
www.hp.com/support/rbsu.
Entry Models
(Non hot plug)
Base Models
(Hot plug)
Performance Models
(Hot plug)
NOTE: The DL320e Gen8 can support other advanced controllers as well, depending on model and
configuration
NOTE: For set up instructions for HP Smart Array B120i SATA Controller please refer to the HP ProLiant
DL300 series server user guide.
NOTE: For general information about HP Smart Array B120i SATA RAID Controller, please visit:
http://h18004.www1.hp.com/products/servers/proliantstorage/arraycontrollers
/dynamicsmartarray/index.html
Optical Drive
Hard Drives
One of the following
depending on Model
Hard Drive Bays
DA - 14326 Worldwide — Version 21 — December 13, 2013
HP ProLiant DL320e Generation 8 (Gen8)
HP Dynamic Smart Array B120i Controller
NOTE: Supports 3.0Gb/s SATA.
NOTE: Supports RAID 0/1/10 only. It does not have FBWC support so cannot
support advanced RAID (5 onwards). For FBWC, a standup Smart Array
Controller card must be configured.
HP Dynamic Smart Array B120i Controller
NOTE: Supports 3.0Gb/s SATA.
NOTE: Supports RAID 0/1/10 only. It does not have FBWC support so cannot
support advanced RAID (5 onwards). For FBWC, a standup Smart Array
Controller card must be configured.
HP Smart Array P222/512MB FBWC controller
NOTE: P222 can support RAID 0/1/10/5/5+0/6/6+0.
NOTE: HP Smart Array Advanced Pack (SAAP 2.0) is no longer required to
enable RAID 6 & 60 (Advanced Data Guarding). However, controller must be in
firmware version 4.68 (or later).
None
Optional
DVD-ROM, DVD-RW
None ship standard (Base Models and Performance Models)
1x NHP 500GB SATA 3.5" drive (Entry Models)
8 SFF drive bays or 4 LFF Non hot plug/Hot plug
NOTE: HP ProLiant DL320e Series servers offer both SFF, and LFF versions in
CTO. The Optical Drive bay is available with both models.
NOTE: LFF versions are not an upgradeable option from SFF models, or vice
versa, also between Non Hot Plug LFF and Hot Plug LFF.
NOTE: All Pre-configured Models come populated with some hard drive blanks
installed. Should the customer need additional hard drive blanks, they can
order more using either P/N 666987-B21: HP SFF Gen8 Hard Drive Blank Kit or
P/N 666986-B21: HP LFF Gen8 Hard Drive Blank Kit. These part numbers for
single HDD blanks below are also provided should the customer require
replacement HDD blanks for their server.
Page 4