HP ProLiant DL320e Specification page 3

QuickSpecs
Standard Features
Memory
One of the following
depending on Model
Network Controller
Expansion Slots
HP Server ROM
Type
DIMM Slots Available
Maximum Capacity
(UDIMM)
NOTE: HP memory from previous generation servers are not fully compatible with the HP ProLiant DL320e
Gen8 Server.
NOTE: To realize the performance memory capabilities listed in this document, HP SmartMemory is
required. For additional information, please see the HP SmartMemory QuickSpecs at:
http://h18000.www1.hp.com/products/quickspecs/14225_div/14225_div.html
NOTE: Depending on the memory configuration and processor model, the memory speed may run at
1600MHz, 1333MHz, or 1066MHz. Please see Memory Population Table or the Online Memory
Configuration Tool at: www.hp.com/go/ddr3memory-configurator.
HP Ethernet 1Gb 2-port 330i Adapter
NOTE: The HP ProLiant DL320e Gen8 server has an embedded dual-port network adapter . The server can
be further upgraded with various networking products
Expansion Technology
Slots #
1 PCIe 2.0
2 PCIe 3.0
*Indicates the number of physical electrical lanes running to the connector.
NOTE: PCIe 3.0 support with Intel Xeon E3-1200v2 family only.
HP ROM (Read Only Memory) is now digitally signed using HP's Corporate Signing Service. This signature is
verified before the flash process starts, reducing accidental programming and preventing malicious efforts
to corrupt system ROM.
HP ROM provides for essential initialization and validation of hardware components before control is
passed to the customer-installed operating system. The ROM also provides the capability of booting from
various fixed media (HDD, CD-ROM) and removable media (USB), to continue operation to the operating
system.
HP ROM performs very early configuration of the video controller, to allow monitoring of initialization
progress via an attached monitor. If configuration or hardware errors are discovered during this early
phase of hardware initialization, suitable messages are now displayed on the connected monitor.
Additionally, these configuration or hardware errors are logged to the Integrated Management Log (IML) to
assist in diagnosis.
HP's ProLiant ROM is used to configure the following:
Processor and chipset status registers
System memory, memory map, and memory initialization
System hardware configuration (Integrated PCI devices and optional PCIe cards).
DA - 14326 Worldwide — Version 21 — December 13, 2013
HP ProLiant DL320e Generation 8 (Gen8)
HP SmartMemory
Unbuffered (UDIMM)
4 DIMMs (2 Channels/ 2 DIMMs per channel)
32GB (4 x 8GB@1600MHz)
Bus
Width*
x4
x16
Connector Form Factor
Width
x8 Low profile slot
x16 Half-length, full-
height slot
Notes
Page 3