GE JSP60GN Use And Care & Installation Manual page 31

Delay Start is setting the oven timer to start the clean
cycle automatically at a later time than the present
time of day.
NOTE: Before beginning, make sure the oven clock
shows the correct time of day.
Quick Reminder:
1. Prepare oven for cleaning.
2. Slide the oven door latch to the right as far as
it will go.
3. Push the STOP TIME button.
4. Set the desired time you want the oven to stop.
Turn the SET knob clockwise until the Stop
Time you desire appears in the display.
5. Push the CLEAN button.
6. Turn the SET knob 1/2 turn. Time that appears is
For example: Let's say it's 7:00 and you want the
oven to begin self-cleaning at 10:30 after you're
finished in the kitchen. The oven is soiled a normal
1. Prepare the oven for cleaning.
2. Close the oven door and
make sure the light is off.
Slide the latch handle to the
right as far as it will go.
NOTE:
You can find out when the clean cycle will be
finished by pushing the STOP TIME button.
The word " DOOr" is displayed when you try to set
the clean cycle with the door open or when the oven
temperature is too high.
Clean Time is normally 3 X hours. Y@trcm c na@
To Stop a Clean Cycle
1. Press the CANCEL button.
2. Wait until the oven has cooled below locking temperature and the word
"LOCK" is off in the display. You will not be able to open the door right
away unless the oven temperature is at a safe level.
3. Push STOP TIME button.
4. Turn the SET knob to time of day when you wish
cleaning to be completed (must be more than
5. Push the CLEAN button.
6. Turn the SET knob in a clockwise direction about
The words "DELAY CLEAN" will be on in the
display until the clean cycle starts. After the clean
cycle starts, the word "CLEAN" will be on in the
display.
7. When the word "LOCK" is not displayed, and the
oven has cooled, slide the latch handle to the left as
far as it will go and open the oven door.
force the latch handle. Wait
Never
until the word "LOCK" goes out
in the display and the latch slides
easily. Forcing the latch handle
may damage the door lock.
NOTE: During a delayed self-clean
operation, you can find out when the oven will begin
the self-clean cycle by pushing and holding the
CLEAN button.
If "F-" and a number flash on the display, and
the control beeps, this indicates a function error
code. Press the CANCEL button. Allow oven to
cool for 1 hour. Put oven back into operation. If
function error code repeats, disconnect power to the
range. Call for service.
If the self-cleaning mode malfunctions, turn off and
disconnect the power supply. Have serviced by a
qualified technician.
,
31