Wireless Ap - NETGEAR N600 User Manual

2. Click Add to add a wireless device to the wireless access control list.
The Wireless Card Access Setup screen opens and displays a list of currently active
wireless cards and their Ethernet MAC addresses.
3. If the computer or device you want is in the Available Wireless Cards list, select that radio
button; otherwise, type a name and the MAC address. You can usually find the MAC
address on the bottom of the wireless device.
Tip: You can copy and paste the MAC addresses from the Attached Devices
screen into the MAC Address field of this screen. To do this, use each
wireless computer to join the wireless network. The computer should
then appear in the Attached Devices screen.
4. Click Add to add this wireless device to the Wireless Card Access List. The screen changes
back to the list screen.
5. Add each computer or device you want to allow to connect wirelessly.
6. Select the Turn Access Control On check box.
7. Click Apply.

Wireless AP

You can set up the router to run as an access point (AP) on the same local network as
another router.
To set up the router as an AP:

1. Select Advanced > Advanced Setup > Wireless AP.
N600 Wireless Dual Band Gigabit Router WNDR3700v4
Advanced Settings
74