NETGEAR WNDR3700v4 Installation Manual

Installation Guide
N600 Wireless Dual Band Gigabit Router
WNDR3700v4
Package Contents
Ethernet cable
N600 Wireless Router
Power adapter
Step 1: Step 2:
Connect one end of the
Unplug the power
yellow Ethernet cable
to turn off your modem.
to your modem, and the
other end to the Internet
port on your router.
DSL
Internet
Power On/Off
Modem
Step 3:
Plug in the power to
turn on your modem.
Wait approximately 2 minutes
until your modem turns on.
If your modem has
a battery backup,
first remove and reinsert
the battery before connecting
your modem to power.
Power On/Off
N600 Wireless Router
Step 4:
Connect the power adapter to the
router, then plug it into an outlet.
Wait for the 2.4 GHz LED ( )
2.4
GHz
to light.
If none of the LEDs light, make sure
that the Power On/Off button is in the
on position (pushed in).
(not included)
Laptop or desktop
computer
Step 5:
Connect your computer
to the router ( ).
Use another Ethernet cable to
establish a wired connection
as shown in this diagram.
Optionally, connect wirelessly
by using the preset wireless
security settings, located on
the bottom label.
Step 6:
Open a browser.
If the web page does not
display, close and re-open
the browser, then enter
http://www.routerlogin.net
in the address bar, or
check the "Troubleshooting"
section on the back of
this installation guide.