NETGEAR N300 User Manual page 152

N300 Wireless ADSL2+ Modem Router DGN2200v3
The resulting screen should show Update OK: good:
4. Configure the DGN2200v3 as in the gateway-to-gateway procedures using the VPN Wizard
(see Set Up a Gateway-to-Gateway VPN Configuration
appropriate network addresses for the environment.
The LAN addresses used in this example are as follows:
Device
DGN2200v3
FVL328
a. Enter toFVL328 for the connection name.
b. Enter fvl328.dyndns.org for the remote WAN's IP address.
c. Enter the following:
• IP Address: 172.23.9.1
• Subnet Mask: 255.255.255.0
5. Configure the FVL328 as in the gateway-to-gateway procedures for the VPN Wizard (see
Set Up a Gateway-to-Gateway VPN Configuration
appropriate network addresses for the environment.
a. Enter toDG834 for the connection name.
b. Enter dg834g.dyndns.org for the remote WAN's IP address.
c. Enter the following:
• IP Address: 10.5.6.1
• Subnet Mask: 255.255.255.0
6. Test the VPN tunnel by pinging the remote network from a PC attached to the DGN2200v3.
a. Open the command prompt (Start -> Run -> cmd)
LAN IP Address LAN Subnet Mask
10.5.6.1 255.255.255.0
172.23.6.1 255.255.255.0
VPN Configuration
152
on page 117), being certain to use
on page 117), being certain to use