Configuration Information - Factory Integrated Models - HP ProLiant DL160 Quickspecs

QuickSpecs

Configuration Information - Factory Integrated Models

NOTE: This section lists some of the steps required to configure a Factory Integrated Model. To ensure only valid configurations are
ordered, HP recommends the use of an HP approved configurator. Contact your local sales representative for information on
configurable product offerings and requirements.
NOTE: Configure-to-order (CTO) servers must start with a CTO Chassis.
NOTE: FIO indicates that this option is only available as a factory installable option.
NOTE: Rail kits and cable management solutions are optional in CTO. See "Step 3: Choose Additional Factory Integratable Options" for
details on ordering.
NOTE: The DL160 ships standard with the HP Dynamic Smart Array B120i Controller which provides support for up to 4 SATA drives
(data transmission speeds up to 3Gb/s). Customers requiring more than 4 drives or SAS support are required to choose a HP Smart
Array controller
NOTE: Power Supply not included - choose from Power Options section.
NOTE: All Factory Integrated Models will be populated with sufficient hard drive blanks based on the number of initial hard drives
ordered with the server
Step 1: Base Configuration (choose one of the following configurable models)
HP Models HP ProLiant DL160 Gen8 SFF Configure-to-order Server
Factory Integrated Model ships with:
2 x HP Smart Socket Guides for fast processor installation
HP 361i Integrated Dual Port Gigabit Server Adapter
Drive cage: Eight small form factor
I/O Slots- Two std
(1) FH/FL x16 PCIe 3.0 or (1) FH/HL x16 PCIe3.0 and (1)low profile x8 PCIe 3.0
(1)FlexibleLOM slot for networking upgrade
(24) DIMM slots for DIMMs installation
HP Dynamic Smart Array B120i controller
(5) Non-hot plug redundant fans
(7) USB ports-4 rear, 2 front, 1 internal
HP iLO Management Engine (standard)
Rack (1U), (1.75 in / 4.45 cm)
Power supply not included- Please choose from the power supply option section in Step
2 below.
HP ProLiant DL160 Gen8 LFF Configure-to-order Server
Factory Integrated Model ships with:
2 x HP Smart Socket Guides for fast processor installation
HP 361i Integrated Dual Port Gigabit Server Adapter
Drive cage: Four large form factor
I/O Slots- Two std
(1) FH/FL x16 PCIe 3.0 or (1) FH/HL x16 PCIe3.0 and (1)low profile x8 PCIe 3.0
(1)FlexibleLOM slot for networking upgrade
(24) DIMM slots for DIMMs installation
HP Dynamic Smart Array B120i controller
(5) Non-hot plug redundant fans
(7) USB ports-4 rear, 2 front, 1 internal
HP iLO Management Engine (standard)
Rack (1U), (1.75 in / 4.45 cm)
Power supply not included- Please choose from the power supply option section in Step
2 below.
HP ProLiant DL160 Gen8 Non-hot Plug LFF Configure-to-order Server
DA - 14282 Worldwide — Version 22 — December 13, 2013
HP ProLiant DL160 Generation 8 (Gen8)
666281-B21
666282-B21
685622-B21
Page 20