Table of Contents
Advertisement
Disassembling and reassembling
the blade, pockets and teeth
IMPORTANT INFORMATION
The cutters and pockets are mounted on the
cutting wheel as illustrated.
L = Left mounting
R = Right mounting
Ensure that the tooth cutters are turned in
the cutting direction.
WARNING!
The cutters can come loose from
the cutting wheel if the screws are
not sufficiently tight. Comply with
the recommended torque settings.
Hold the teeth (30-31) in place as in the upper
diagram when mounting the pockets (32-33). Risk
for incorrect assembly.
Insert the screw (34) in one pocket (32), through
the blade section (28) and out though the pocket
(33) on the other side.
Make sure that the roll pins in the back edge of the
teeth are seated against the back of the pockets.
This provides the correct gauging of the cutter
edge.
Tighten the screws 162-203 Nm.
Removing and refitting the wheels
To remove the left wheel (8) from the stump grinder,
remove the locking collar (9), the 1/4" screws (10),
the 1/4" hex nuts (3), the springs (4) and the brake
pad (7). The wheel can now be removed from the
axle.
To remove the right wheel (2), remove the locking
collar (1) and slide the wheel off the axle.
32 – English
MAINTENANCE
8011-215
8011-216
8011-217
Advertisement
Table of Contents
