Cleaning The Cyclone Filter - Husqvarna SG11 Operator's Manual

Cleaning the cyclone filter

The cyclone filter collects the largest contaminant
particles, which collect in the container. When you
can see a layer of dirt at the bottom of the
container, the cyclone housing (4), air channels and
air intake screen (3) must be cleaned.
Remove the three screws holding the cyclone
housing. Remove the housing with the air intake
screen and remove the air channels.
The air channels may remain in the upper portion or
follow along with the housing when removed.
Clean the components. Use water, detergent and a
washing-up brush. Dry carefully.
IMPORTANT INFORMATION
Exercise care when reassembling to avoid
damaging anything.
Make sure when mounting that the air intake
screen fits exactly in its guide in the upper
portion.
Make sure the air channel ends up in the
proper position.
Refit the components. Place the air channels in the
cyclone housing. Insert cyclone housing into
position and make sure it fits in the upper portion.
Do not use force; rather coax it into place before
fitting the screws.
MAINTENANCE
8011-188
8011-213
8011-212
8011-213
English – 27