Assembly And Installation - MULTIQUIP js36h55 Operation And Parts Manual

7. Adjustment of the throttle cable tension may be
required. If so, loosen the adjusting nut (top nut) on
the throttle cable receiver (Figure 7) and loosen or
tighten the locking nut (bottom nut). Retighten
adjusting nut.
ADJUSTING
NUT (TOP)
Figure 7. Throttle Cable Receiver Adjustment
NOTICE
If the throttle lever does not return to the "neutral"
position with throttle backed off, loosen adjuster nut 1/2
turn at a time, tighten and recheck. Readjust throttle
tension as necessary.
Safety Stop Switch connection
1. Connect the black tail wire from the engine to the top
black safety stop wire from the centrifugal stop switch
as shown in in Figure 8.
Figure 8. Safety Stop Switch Connection
2. Remove the existing bottom mounting screw on the
recoil starter cover (Figure 9) and connect the bottom
wire from the centrifugal stop switch to this engine
ground point.
RECOIL
STARTER
COVER
CENTRIFUGAL
STOP SWITCH
EXISTING
O N
SCREW
BOTTOM
Figure 9. Engine Ground Point
page 18 — jS36 SeRIeS WaLK-BeHINDTROWeL • OpeRaTION aND paRTS maNUaL — Rev. #4 (11/01/13)
LOCKING NUT
(BOTTOM)
SAFETY STOP WIRE
CONNECTION POINT
CENTRIFUGAL
STOP SWITCH
TOP SAFETY
STOP WIRE
BLACK
TAIL WIRE
FUEL TANK
ENGINE
GROUND
POINT

assembly and installation

pitch cable installation
1. For Standard Handle models expose the pitch cable
to maximum by turning the blade pitch star wheel
(Figure 10) fully counterclockwise for no pitch (blades
flat).
INCREASE
BLADE PITCH
(CW)
Figure 10. Blade Pitch Star Wheel
2. For Quick Pitch™ Handle models expose the pitch
cable to maximum by grasping the T-handle (Figure 11),
then squeezing the trigger lock and pushing the
T-handle forward for no pitch (blades flat).
T-HANDLE
TRIGGER
(SQUEEZE)
NO PITCH
FORWARD
Figure 11. Blade Pitch T-Handle
(Quick Pitch™ Handle)
3. Remove brass set nut #1 from the blade pitch cable
end as shown in (Figure 12).
BRASS SET
NUT #1
Figure 12. Blade Pitch Cable
4. Thread brass set nut #2 (Figure 12) towards the cable
as far as possible.
5. Insert the cable end through the yoke eyelet
(Figure 13). Tighten brass set nut #1 by hand to remove
all the slack from the cable.
DECREASE
BLADE PITCH
(CCW)
(Standard Handle)
BLADE
PITCH
CABLE
BRASS SET
NUT #2