NETGEAR N300 User Manual page 58

3. Click Add to add a service.
The Block Services Setup screen displays:
4. From the Service Type drop-down menu, select the application or service to allow or block.
The menu already displays several common services, but you are not limited to these
choices. To add any additional services or applications that do not already appear, select
User Defined.
5. From the Protocol drop-down menu, select TCP, UDP, or TCP/UDP.
If you know that the application uses either TCP or UDP, select the appropriate protocol.
If you are not sure, select TCP/UDP.
6. Enter the starting and ending port numbers.
If the application uses a single port number, enter that number in both fields.
7. Select the radio button for the IP address configuration you want to block, and enter the IP
addresses.
You can block the specified service for a single computer, a range of computers with
consecutive IP addresses, or all computers on your network.
8. Click Add to enable your Block Services Setup selections.
N300 Wireless Router JWNR2000v3
Security
58