Signal Menu - Panasonic TH-50PB2U Operating Instructions Manual

SIGNAL menu

Notes:
• "SIGNAL" setup menu displays a different setting condition for each input signal.
• Depending on the input signal type, an optional Terminal Board may be required.
Select "SIGNAL" in "SETUP" menu and press
For VIDEO (S VIDEO)
[ VIDEO ]
SIGNAL
3D Y/C FILTER (NTSC)
ON
AUTO
COLOR SYSTEM
3 : 2 PULLDOWN OFF
NOISE REDUCTION OFF
For COMPONENT
[ COMPONENT ]
SIGNAL
SYNC
AUTO
3 : 2 PULLDOWN OFF
XGA MODE AUTO
NOISE REDUCTION OFF
H-FREQ. 63.98 kHz
V-FREQ. 60.02 Hz
SIGNAL FORMAT 1280×1024/60i
• 3D Y/C FILTER (NTSC)
This menu is displayed when BNC Dual Video Terminal Board (TY-FB9BD) is installed to the unit.
Set this menu when the moving image looks unnatural during Video (S Video) input signal.
ON OFF
Note:
When ON, this setting only affects NTSC input signals.
• COLOR SYSTEM
AUTO PAL
Set the color system to match the input signal. When "AUTO" is set, COLOR SYSTEM will be automatically selected
from NTSC/PAL/SECAM/M.NTSC.
To display PAL60 signal, select "AUTO" or "PAL".
If the image becomes unstable:
With the system set on Auto, under conditions of low level or noisy input signals the image may in rare cases become
unstable. Should this occur, set the system to match the format of the input signal.
• 3:2 PULLDOWN
When "ON", the display attempts to reproduce a more natural interpretation of sources such as movie pictures, which
are recorded at 24 frames per second.
If the picture is not stable, turn the setting to "OFF".
ON OFF
Note:
When ON, this setting only affects the following signal input:
• NTSC / PAL signal input during Video (S Video) input signal.
• 525i(480i), 625i(575i), 1125(1080)/60i signal input during "COMPONENT" input signal.
• XGA MODE
This menu is displayed when the input signal is analog (Component/PC).
This unit supports three types of XGA signals with 60Hz vertical frequency having different aspect ratios and sampling
rates (1,024 × 768 @ 60Hz, 1,280 × 768 @ 60Hz and 1,366 × 768 @ 60Hz).
AUTO 1024×768
AUTO: Automatically selected from 1024×768/1280×768/1366×768.
Switch the setting to suit the input signal for better display depends on the angle of view or display resolution condition.
Note:
After making this setting, be sure to make each adjustment (such as "AUTO SETUP") on the "POS./SIZE" menu as
necessary. (see page 24)
button.
For RGB
SIGNAL
SYNC
AUTO
3 : 2 PULLDOWN OFF
XGA MODE AUTO
NOISE REDUCTION OFF
H-FREQ. 63.98 kHz
V-FREQ. 60.02 Hz
SIGNAL FORMAT 1280×1024/60i
For Digital
SIGNAL
3 : 2 PULLDOWN
OFF
HDMI RANGE AUTO
NOISE REDUCTION OFF
H-FREQ. 63.98 kHz
V-FREQ. 60.02 Hz
SIGNAL FORMAT 1280×1024/60i
SECAM M.NTSC
1280×768 1366×768
SETUP for Input Signals
[ RGB ]
[ Digital ]
NTSC
49