Panasonic TH-50PB2U Operating Instructions Manual page 37

STANDBY PEN CHARGING MODE
Sets the power supply for the electronic pen charging terminal (CHARGE, MEMORY/(CHARGE)) in the standby mode
(power OFF with remote control).
OFF: Turns off the charging terminal power in the standby mode.
ON[4hrs]: Turns ON the charging terminal power for 4 hours after entering standby mode.
ON: Leaves the charging terminal power ON in standby mode so that the pen can be charged.
PAIRING
Registers an electronic pen to electronic pen adapter.
Up to four electronic pens can be registered for an electronic pen adapter.
For the details of the pairing, please refer to "Operating Instructions, Electronic Pen Operations".
Note:
Make sure the electronic pen adapter is connected to the display.
If no electronic pen has been registered, the screen of procedure
the screen to register an electronic pen.
1
Select "PAIRING" in "TOUCH PEN SETTINGS"
and press button.
2
Select "Pairing" and press
Pairing Tool
Pairing
Unpairing All
Close
3
While pressing both the remote drawing and the remote
clearing buttons of the electronic pen, press the Power
switch.
To cancel the paring, select "Cancel".
Pairing in progress
Set the electronic pen that you want to pair as
pair-enabled and then move it closer to the
electronic pen adapter. For details, refer to the
procedure for registering electronic pens in the
operating instructions for the electronic pen.
Cancel
[Unpairing]
Unpairs all paired electronic pens.
1
Select "Unpairing All" in "Pairing Tool" and press
2
Select "Yes" and press
Pairing Tool
Do you want to cancel all pairings?
Yes
PEN ADAPTER STATUS
NOT DETECTED: Electronic pen adapter is not connected.
CONFIRMING...: Immediately after connecting an electronic pen adapter and the built-in WhiteBoard "Easy WhiteBoard"
is starting up.
DETECTED: Electronic pen adapter is connected.
button.
button.
No
TOUCH-PEN SETTINGS
3
appears fi rst. Follow the instructions on
4
When the electronic pen paring is completed,
select "Return" and press
Pairing Tool
Pairing was successful.
5
Select "Close" and press
Pairing Tool
button.
button.
Return
button.
Pairing
Unpairing All
Close
37