Adjusting Pos./Size - Panasonic TH-50PB2U Operating Instructions Manual

Adjusting POS./SIZE

1
2
3
4
Notes:
• POS./SIZE cannot be adjusted with two screen display.
• Adjustment details are memorized separately for different input signal formats. (Adjustments for component signals are
memorized for 525 (480) / 60i · 60p, 625 (575) / 50i · 50p, 1125 (1080) / 60i · 50i · 60p · 50p · 24p · 25p · 30p · 24sF,
1250 (1080) / 50i, 750 (720) / 60p · 50p each, and RGB/PC/Digital signals are memorized for each frequency.)
• If a "Cue" or "Rew" signal from a VCR or DVD player is received, the picture position will shift up or down. This picture
position movement cannot be controlled by the POS./SIZE function.
AUTO When inputting a PC signal as an example, "H-POS/V-POS", "H-SIZE/V-SIZE", "DOT CLOCK" and
SETUP "CLOCK PHASE" are automatically corrected.
This setting is enabled under the following conditions:
• When inputting an analog signal (Component/PC):
This setting is enabled if "COMPONENT/RGB-IN SELECT" (see page 48) in SETUP menu is "RGB".
• When inputting a digital signal (HDMI/DVI):
A PC format signal enables this setting.
When the signal is not PC format, this setting is enabled only if "OVER SCAN" (see page 25) is "OFF" or
"1:1 PIXEL MODE" (see page 26) is "ON." H-SIZE/V-SIZE is not automatically adjusted.
This setting will be invalid and will not work under the following conditions:
• When NETWORK input is selected.
• When VIDEO signal input
• During two screen or Digital Zoom.
• Aspect is set to "JUST"
• "Display size" in the Options menu (see page 53) is set to "On"
Using Remote Control
Auto mode
When the "Auto Setup" is set to "Auto" in the Options menu (see page 54), automatic position adjustment starts:
• When the display power is turned ON.
• When the input signal is switched.
24
Press to display the POS./SIZE menu.
Press to select the menu to adjust.
Press to adjust the menu.
Press to exit from adjust mode.
When on the remote control is pressed, "AUTO SETUP" will be executed.
When AUTO SETUP does not work, "INVALID" is displayed.
POS./SIZE
NORMALIZE
NORMAL
AUTO SETUP
0
H-POS
0
H-SIZE
0
V-POS
0
V-SIZE
0
DOT CLOCK
0
CLOCK PHASE
0
CLAMP POSITION
1:1 PIXEL MODE OFF
Note:
Unadjustable items are
grayed out.
Adjustable items differ
depending on the input signal
and the display mode.