Homelink Integrated Homelink Wireless Control System; Programming Homelink - Hyundai Santa Fe Owner's Manual

Features of your vehicle
1. Press and hold the button for more
than 6 seconds. When the compass
memory is cleared a "C" will appear in
the display.
2. To calibrate the compass, drive the
vehicle in 2 complete circles at less
than 5 mph (8 km/h).
Integrated HomeLink ® Wireless Control
System
The HomeLink® Wireless
System provides a convenient way to
replace up to three hand-held radio-fre-
quency (RF) transmitters with a single
built-in device. This innovative feature will
learn the radio frequency codes of most
current transmitters to operate devices
such as gate operators, garage door
openers, entry door locks, security sys-
tems, even home lighting. Both standard
and rolling code-equipped transmitters
can be programmed by following the out-
lined procedures. Additional HomeLink
information can be found at: www.home-
link.com or by calling 1-800-355-3515.
4 34
CAUTION
Before programming HomeLink
a garage door opener or gate oper-
ator, make sure that people and
objects are out of the way of the
device to prevent potential harm or
damage. Do not use HomeLink
with any garage door opener that
lacks the safety stop and reverse
features required by U.S. federal
Control
safety standards (this includes any
garage door opener model manu-
factured before April 1, 1982). A
garage door that cannot detect an
object - signaling the door to stop
and reverse - does not meet current
U.S. federal safety standards. Using
a garage door opener without these
features increases the risk of seri-
ous injury or death.
Retain the original transmitter of the RF
®
device you are programming for use in
other vehicles as well as for future
HomeLink ® programming. It is also sug-
gested that upon the sale of the vehicle,
the programmed HomeLink
erased for security purposes.

Programming HomeLink

✽ ✽ NOTICE
to
®
• When programming a garage door
opener, it is advised to park the vehi-
cle outside of the garage.
• It is recommended that a new battery
be placed in the hand-held transmit-
®
ter of the device being programmed to
HomeLink
accurate transmission of the radio-
frequency signal.
• Some vehicles may require the igni-
tion switch to be turned to the second
(or "accessories") position for pro-
gramming
HomeLink.
• In the event that there are still pro-
gramming difficulties or questions
after following the programming steps
listed below, contact HomeLink
www.homelink.com or 1-800-355-
3515.
® buttons be
®
® for quicker training and
and/or operation of
® at: