Cisco TrustSec Configuration Manual page 98

cts dot1x
cts dot1x
Use the cts dot1x command to enter CTS dot1x interface configuration mode (config-if-cts-dot1x) to
configure the TrustSec reauthentication timer on an interface. Use the no form of the command to disable
the timers on an interface.
Syntax Description This command has no arguments or keywords.
Defaults CTS dot1x configuration on the interface is disabled by default.
Command Modes
Interface configuration (config-if)
Supported User Roles Administrator
Command History Release
12.2 (33) SXI3
Usage Guidelines
Before configuring the TrustSec dot1x reauthentication timer, configure dot1x globally from the
interface from the Interface Configuration mode. The CTS dot1x configuration governs TrustSec NDAC,
not TrustSec EAC processes.
Examples
In the following example, a Catalyst 6500 Series switch enters CTS configuration mode without first
enabling dot1x in interface configuration mode:
Router(config-if)# cts dot1x
Warning: Global dot1x is not configured, CTS will not run until dot1x is enabled
. (Gi3/1)
Router(config-if-cts-dot1x)# ?
CTS dot1x configuration commands:
default
exit
no
timer
Cisco TrustSec Configuration Guide
7-12
[no] cts dot1x
Modification
This command was introduced on the Catalyst 6500 series switches.
Set a command to its defaults
Exit from CTS dot1x sub mode
Negate a command or set its defaults
CTS timer configuration
Chapter 7 Cisco TrustSec Command Summary
OL-22192-01