Using The Multimedia Remote Control - Sanyo DS27820 Owner's Manual

USING THE MULTIMEDIA REMOTE CONTROL

Operates your TV, VCR, DVD, and Cable converter box. To program the remote control,
see pages 8 ~ 10.
INSTALL BATTERIES AS SHOWN (2 AA, not included)
Notes:
– Do not mix old batteries with new ones or mix
different types of batteries together.
– Remove the batteries if the remote control will not be used
for a month or more. Weak batteries may leak and cause damage.
(Normal battery life is roughly six months.)
IMPORTANT NOTE: Spent or discharged batteries must be recycled or dis-
posed of properly in compliance with all applicable laws. For detailed
information, contact your local County Solid Waste Authority.
REMOTE CONTROL KEYS
Œ
Mode Keys—Use these keys to program the remote control and to select the operating
mode (VCR, TV, or AUX).
To Operate Your...VCR—Press the VCR key. Cable Box or DVD Player—Press the
AUX key. Television—Press the TV key.
Note: Be sure to hold down the mode key while entering a code number, see page 8.

Input Key—Press to select the program source:
TV signal or signal from the DVD Player or other
equipment you have connected to the A/V jacks.
Ž
Number Keys—Two keys must be pressed to
select a channel. Example: Press 0 then 6 to select
channel 6. For cable channels 100 through 125,
press and hold the 1 key until C1–– appears. Then
press the other two numbers.

Caption Key—See page 13.

Menu Key—Use this key with the
keys to navigate and adjust features of the
on-screen menu system (see pages 11 ~ 13).
‘
Channel Scanning (CH
(VOL – – /+ + ) Keys—Press to scan through the
channels in memory and to adjust the volume.
’
Mute Key—Press once to minimize the volume.
Press again to restore. Note: When using the audio
out jacks this key will not mute the sound.
“
VCR/ DVD Keys—These keys control VCR or DVD
functions for Fast Forward ( ), Rewind ( ), Play ( ),
•
Record (REC ), Stop (
L/M
and – – /+ +
L / M
) and Volume
I
), and Pause (II).
Œ

Ž


‘
’
“
(Continued on page 8.)
QuickTips
Be sure batteries are
I
installed correctly.
Point the remote
I
control toward the
equipment you want
to operate. Objects
between the remote
control and the
equipment may
cause misoperation
of the remote control
function.
If the remote control
I
does not work: Press
T T V V key (see item 1).
The remote control
I
must be programmed
before it will operate
your VCR, DVD
Player, or Cable Box.
See pages 8~10.
Note: Sanyo VCR
and DVD codes are
preprogrammed.
Cannot select
I
channel with number
keys. Press "0" in
front of numbers 1 ~
9. Example: Channel
05.
Adjusting the volume
I
level: Right flashing
arrow indicates
volume is increasing
and Left flashing
arrow indicates
volume is decreas-
ing.
N N e e e e d d h h e e l l p p ? ?
V V i i s s i i t t o o u u r r W W e e b b s s i i t t e e a a t t
www.sanyoctv.com
o o r r C C a a l l l l 1 1 - - 8 8 0 0 0 0 - - 8 8 7 7 7 7 - - 5 5 0 0 3 3 2 2
7 7
7