Assembly - Weslo Cadence 50 Ls User Manual

ASSEMBLY

Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials until assembly is completed. Assembly requires the included allen wrench
and your own phillips screwdriver
Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a
small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a nor-
mal condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply
wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.
Nut (2)–4
Handrail Washer (39)–4
WARNING:
cord until the treadmill is completely assembled.
1. Note that the Right Handrail and the Console Base (not
shown) are connected to the treadmill by a Wire
Harness. During assembly steps 1 to 3, be careful not
to pull on or damage the Wire Harness.
With the help of a second person, carefully lay the tread-
mill on its side. Position one of the Base Legs (55) on the
base of the Upright (37) as shown. Make sure that the
Base Leg Pads (31) and the Wheel (34) are in the indi-
cated positions. Attach the Base Leg with two Base Leg
Bolts (28), two Base Leg Washers (68), and two Nuts (2).
Carefully turn the treadmill onto its other side. Assemble
the other Base Leg (55) as described.
With the help of a second person, carefully raise the
treadmill to the upright position so that both Base Legs
(55) are resting flat on the floor.
2. Attach the Storage Latch (38) to the left Upright (37) with
two Screws (90). Be careful not to overtighten the
Screws.
Screw (90)–6
Base Leg Washer (68)–4
Do not plug in the power
and two adjustable spanners
Handrail Bolt (11)–4
Base Leg Bolt (28)–4
1
37
2
38
5
.
28
55
68
31
34
2
37
90