Supported Phone - ZyXEL Communications P-27xx Series User Manual

The following table describes the labels in this screen.
Table 7 Dial Plan with URL
LABEL
Index
Port Setting
(P-2702R only)
SIP Number
Destination
Active
Remove
Selected
Remove All
Apply
Reset
3.6 Supported Phone Functions
The following table shows the key combinations you can enter on your phone's
keypad to use certain features after you pick up the phone's receiver.
Note: After pressing the flash key, if you do not issue the sub-command before the
default sub-command timeout (2 seconds) expires or issue an invalid sub-
command, the current operation will be aborted.
Note: If the flash key is not available, you can tap (press and immediately release) the
hook by hand to achieve the same effect.
Table 8 Call Features
KEY
FUNCTION COMBINATIONS USA
Call-Hold / Call- FLASH
Retrieve
FLASH 0
FLASH 1
P-27XX Series User's Guide
DESCRIPTION
This indicates the index number of each entry.
Select the phone port you want to configure here.
Enter the SIP number you want the ZyXEL Device to call.
Enter the IP address or domain name of the party you want to call when
you dial the corresponding SIP number to make a peer-to-peer call.
Check this to select an entry so it can be enabled, removed or moved
up/down.
Click this to clear the settings for the selected entry(ies).
Click this to clear the settings for all entries.
Click the icon to change the position of an entry in the list.
Click this to save your changes and then return to the previous screen.
Click this to reset the options in this screen to their defaults.
1. Put the current call on hold
and create a dial tone.
2. Switch back and forth
between two calls.
Chapter 3 Phone Use and Configuration
EUROPE (DEFAULT)
1. Put the current call on hold
and create a dial tone.
2. Switch back to the first call
(if there is no second call).
Drop a call previously put on
hold.
Drop the current call and
resume a call previously put
on hold.
27