Performing Keystone Correction; Performing Keystone Correction In The Horizontal Direction; Performing Keystone Correction In The Vertical Direction - Denon DVD-3930 Operating Instructions Manual

Other settings
¢ When the signal format is set to "PC RES.":
When operating from the remote control unit:
[HDMI FORMAT]
Use and select the resolution.
When operating from the main unit :
< VIDEO MODE >
q q
Turn to display "HDMI SELECT" on
< VIDEO MODE >
the display, then press
< VIDEO MODE >
w w
Turn and select the resolution, then
< VIDEO MODE >
press .
VGA (Upon purchase):
The signal is converted to a resolution of 640 x 480 (60 Hz).
XGA:
The signal is converted to a resolution of 1024 x 768 (60 Hz).
WXGA:
The signal is converted to a resolution of 1280 x 768 (60 Hz).
SXGA:
The signal is converted to a resolution of 1280 x 1024 (60 Hz).

Performing keystone correction

Keystone distortion occurs when the connected projector or screen is
at an angle. If so, correct.
Valid for progressive and HDMI outputs.
.
• The keystone correction is not reflected in the video output until the
< VIDEO MODE > is pressed to set it. To fine-adjust, repeat step
3 seconds of pressing < VIDEO MODE >.
Performing keystone correction in the horizontal
direction
1 < VIDEO MODE >
Turn
the display, then press
2 < VIDEO MODE >
Turn
correction, then press
The setting can be set to between –40 and +40.
When turned clockwise:
When turned counterclockwise:
Performing keystone correction in the vertical
direction
1
2
2
within
When turned clockwise:
to display "KEYSTONE-H" on
< VIDEO MODE >
.
to select the amount of
< VIDEO MODE >
. When turned counterclockwise:
NOTE:
• The greater the amount of keystone correction, the greater the
• The image size changes when keystone correction is performed.
• The "KEYSTONE" indicator on the front panel lights when keystone
correction is set.
30
ENGLISH
< VIDEO MODE >
Turn to display "KEYSTONE-V" on
< VIDEO MODE >
the display, then press
< VIDEO MODE >
Turn to select the amount of
< VIDEO MODE >
correction, then press
The setting can be set to between –30 and +30.
loss of picture quality. For good picture quality, set the devices so
that the correction value can be kept to the minimum.
ENGLISH
Other settings
.
.