Software Information; Calling Up Software Information; Additional Information For Units Sold In The Uk - Grundig GDP 1100 User Manual

INFORMATION __________________________________________
Player Model: GDP1100 R:2
SW-Version: 0.04/06.11.2003
Copyright Grundig AG
http://www.grundig.com

Software information

We wish to point out explicitly that only operating software authorised by GRUNDIG is
permissible for the DVD player. This operating software is available from specialist deal-
ers or will be available shortly on the Grundig web sites www.grundig.com and
www.grundig.de. Any instance of operating software from a dubious Internet source
being loaded to the device will impair functioning and also, since it is an unauthorised
intervention, invalidate any claims under the guarantee.
GRUNDIG will refuse to refund any costs resulting in such cases. Any repair costs in such
cases, even those occurring within the guarantee period, are to be paid by the customer.

Calling up software information

This function enables you to check the current software status of the DVD player.
1
Switch on the DVD player using »ON/OFF« on the device.
2 Open the disc compartment by pressing » «.
3
Display the software information by pressing »OSD«.
4
To exit the software information display, close the disc compartment by
pressing » «.

Additional information for units sold in the UK.

Units sold in the UK are suitable for operation from a 240V ac, 50Hz mains supply.
The range of multi-system receivers is built to work in most European countries. However, the mains plug and
socket system for the UK differs from many European countries.
This appliance has been supplied with a fitted, non-removable, approved converter plug for use in the UK. This
converter plug is fitted with a 5A rated fuse.
In case this appliance is supplied with a moulded 2-pin Euro plug only, which is unsuitable for UK operation, this
must be cut off and immediately disposed of. An approved 13A, 3-pin UK plug should then be fitted by a
qualified electrician.
Note:
The severed Euro plug must be destroyed to avoid a possible shock hazard should it be inserted into a socket
elsewhere.
If a non-rewireable 3-pin plug or a rewireable 13A (BS1363) 3-pin plug is used, it must be fitted with a 5A
ASTA or BSI approved BS1362 fuse. If any other type of plug is used it must be protected by a 5A fuse either in
the plug, or at the distribution board. If this type of plug becomes defective, ensure that the fuse is removed befo-
re disposal, to eliminate potential shock hazard.
If it is necessary to change the fuse in the non-rewireable plug, the correct type and rating (5A ASTA or BSI
approved BS1362) must be used and the fuse cover must be refitted. If the fuse cover is lost or damaged, the
lead and plug must not be used until a replacement is obtained. Replacement fuse covers should be obtained
from your dealer.
Important:
The wires in the mains lead are colour coded in accordance with the following code:
BLUE – NEUTRAL
BROWN – LIVE
As the colours of the wires in the mains lead of your appliance may not correspond with the coloured marking
identifying terminals in your plug, proceed as follows:
Connect the BLUE coloured wire to plug terminal marked with the letter "N" or coloured black.
Connect the BROWN coloured wire to the plug terminal marked with the letter "L" or coloured red.
In no circumstance must any of the wires be connected to the terminal marked with the letter "E", earth symbol
z
" ", coloured green, or green & yellow.
Replacement mains lead sets can be obtained from your local dealer, or by contacting Grundig Consumer
Relations (01788 570088)
Moulded 3-pin lead set, suitable for UK use:
Ref: Leadset UK
Moulded 2-pin Euro lead set, not suitable for UK use:
Ref: Leadset Euro
8290-991-224
8290-991-316
39