Securing the dishwasher
The dishwasher must be secured to the worktop, this can be done in
one of two ways:-
Standard
o
underside of the worktop by
You should screw through the ho
o
top of the
o These screws should be full
o Marble/granite worktop- T
will mean that it is impossible to put a screw through the
underneath of the worktop.
o On either side of the front edg
there is a rubber stopper. Yo
stoppers, to reveal a pre-drilled hole on either side of the
dishwasher.
o Secure the dishwasher to the cupboard either side of it, by
screwing a wood screw through the pre-drilled holes into
the cupboards. These screws should be fully tightened.
o The rub
original
Before first use
You should check the following before
time:-
o That the dishwasher is level and fixed in position.
o That the water tap is fully open.
o That there are no leaks at either end of the drain or inlet hoses.
o That the inlet and outlet hose are fully tightened.
o That the inlet and outlet hoses are not kinked.
o That the power is switched on.
o That the water softener has been filled with 1 litre of water and
salt.
o That
the
worktop-
Secure
dishwasher cabinet.
ber stoppers should then be refitted into their
position.
rinse
aid
dispenser
the
dishwasher
using two wood screws.
les in the brackets at the
y tightened.
he material of the worktop
e of the dishwasher cabinet,
u should remove the rubber
using the appliance for the first
has
to
the
been
filled.
38