Baumatic BDI631 Insrtuction Manual page 26

Intense and economy wash indicator neons flash
o The machine has sensed water in the base.
Check that the outlet hose is not kinked or crushed.
Check that there are no blockages in the drain hose or the drainage
system that the appliance is connected to.
The drain pipe may be placed in too high a position or incorrectly.
Check the installation instructions and ensure that the installation is
correct.
o Once you have taken action to rectify the problem that has
caused the fault code to appear, plug the machine back into your
mains power supply.
o Turn the machine on using the ON/OFF button and wait for 5
seconds, before attempting to set a wash program, using the
program selection button.
IMPORTANT: If any other combinations of the program
indicator neons flash, you should not attempt to clear it
yourself
Department.
IF THE FAULT CODE REAPPEARS AFTER FOLLOWING
THE ABOVE ADVICE AND CLEARING THE FAULT
CODE. YOU SHOULD TURN OFF THE APPLIANCE;
DISCONNECT THE APPLIANCE FROM YOUR MAINS
SUPPLY. THEN ARRANGE FOR AN ENGINEER TO
ATTEND THE APPLIANCE. YOU SHOULD CONTACT
BAUMATIC
NUMBER (0118) 933 6911.
Please note that if an engineer is asked to attend whilst the product is
under guarantee and finds that the problem is not the result of an
appliance fault, then you may be liable for the cost of the call out
charge.
The appliance must be accessible for the engineer to perform
any necessary repair. If your appliance is installed in such a
way that an engineer is concerned that damage will be caused
to the appliance or your kitchen, then he will not complete a
repair.
This includes situations where appliances have been tiled in,
sealed in with sealant, have wooden obstructions placed in
front of the appliance, like plinths. Or any installation other
than the one specified by Baumatic Ltd. has been completed.
and contact the
CUSTOMER
Baumatic Customer
CARE ON TELEPHONE
Care
26