Assembly - ProForm 500 Ekg Elliptical User Manual

ASSEMBLY

Assembly requires two persons. Place all parts of the elliptical exerciser in a cleared area and remove the
packing materials. Do not dispose of the packing materials until assembly is completed. In addition to the
included hex keys, assembly requires a phillips screwdriver
spanner , and a rubber mallet
Use the chart below to identify the small parts used in assembly. The number in parentheses below each part is
the key number of the part, from the PART LIST on page 14. The number after the parentheses is the quantity
needed for assembly. Note: Some parts may have been preattached for shipping. If a part is not in the
parts bag, check to see if it has been preattached.
M6 Nylon
Locknut (27)–4
M10 Washer
(35)–2
M6 x 38mm Button Bolt (50)–4
1. Identify the Front Stabiliser (10). Whilst another person
lifts the front of the Frame (1), attach the Front
Stabiliser to the Frame with two M8 x 53mm Button
Bolts (34), two M8 Washers (48), and two M8 Nylon
Locknuts (38).
M8 Nylon
Locknut (38)–4 Washer (59)–4
M4 x 20mm
Screw (43)–4
Pedal Arm Bolt
Set (40)–2
.
M8 Split
Washer (48)–4
M6 x 48mm Flat Head
Screw (36)–4
M8 x 53mm Button Bolt (34)–4
1
4
, an adjustable
M8
Wave Washer
(9)–2
M8 x 19mm Button
Screw (68)–4
M10 x 25mm
Patch Screw (22)–2
34
1
10
48
38
48