Information Codes - Panasonic Panafax UF-4000 Operating Instructions Manual

Troubleshooting

Information Codes

When something unusual occurs, the display may show one of the Information Codes listed below. These
will help you to identify and correct the problem.
Info.
Code
001 Recording paper jammed when feeding from the
Paper Tray.
007 Recording paper did not completely exit out of
machine.
010 No recording paper.
030 Document is misfeeding.
031 Document paper is too long or jammed.
Document length exceeds 78.8 inches (2 meters).
041 Out of toner.
043 Toner is getting low.
044 The Life Expectancy of the Drum Unit has been
reached.
045 Drum Unit/Toner Cartridge Assembly is not installed.
061 ADF Door is open.
400 During initial handshake, receiving station did not
respond or communication error occurred.
402 During initial handshake, communication error
occurred.
403 No polling capability at the remote side.
404/405 During initial handshake, communication error
occurred.
407 No confirmation from the receiving station for the
previous page sent.
408/409 Remote side confirmation of previous page is illegible. Wait a few minutes and send again.
410 Communication aborted on the transmitting side.
411 Polling password does not match.
412 No data from the transmitting side.
414 Polling password does not match.
416/417 Received data has too many errors.
418
420/421 Machine goes to receiving mode, but receives no
command from the transmitting side.
422/427 Interface is incompatible.
433/434 Communication error occurred while receiving.
459
436/490 Received data has too many errors.
98
Meaning Action
Remove the jammed paper.
Remove the Drum Unit/Toner Cartridge
Assembly Cartridge and remove the jammed
paper.
Load the recording paper.
1. Reload the document properly.
2. Remove the document jam.
3. Adjust ADF.
1. Reload the document properly.
2. Remove the document jam.
Replace the Toner Cartridge.
Replace the Drum Unit.
Install the Drum Unit/Toner Cartridge Assembly.
Close the ADF Door.
1. Check with the other party.
2. Reload the document(s) and send again.
Reload the document(s) and send again.
Ask remote side to set "POLLED=ON".
Reload the document(s) and send again.
Wait a few minutes and send again.
Check with the other party.
Check the polling password.
Check with the other party.
Check the polling password.
Check with the other party.
1. Remote side misdial.
2. Check with the other party.
Check with the other party.
Check with the other party.
Check with the other party.
page
100
100
17
37
101
104
37
101
15
15
15
--
--
--
--
--
--
--
--
66
--
66
--
--
--
--
--