Bosch MIC Series 550 Installation Manual page 5

5 | MIC Series 550 Infrared Camera
Night Mode
With infrared (IR) (B/W)
SensUp Off
SensUp On
(NTSC: 1/4s, 15X; PAL 1/3s, 16.7X)
Electronic Shutter Speed 1/1 to 1/10,000 sec., 22 steps
Signal-to-Noise Ratio >50 dB
(SNR)
White Balance 2000 K to 10,000 K
2 Unless otherwise stated, test conditions are: F1.35, shutter = NTSC 1/60s, PAL 1/50s;
max AGC
IR Illuminators
LED Array High-efficiency Surface Mount (SMT) LEDs
Number of LEDs 7 per lamp
Wavelength 850 nm (semi-covert)
Beam Angle 30º
DCRI Performance Detection: 150 m (492 ft)
Range Classification: 100 m (328 ft)
(with SensUp ON) Recognition: 75 m (246 ft)
Identification: 60 m (197 ft)
Ingress Protection IP68
Rating
Construction Material Aluminum with Lexan® front window
Mechanical
Drive Unit Brushless, integral pan/tilt motor drive
Pan Range 360° continuous rotation
Tilt Angle 186.6°
Tilt Range Upright unit: -58° - +90°
Canted unit: -103° - +70°
Variable Speed Pan: 0.2°/second - 120°/second
Tilt: 0.2°/second - 60°/second
Pre-position Speed 120°/second
Preset Accuracy 0.17° (typical)
Proportional Pan / Tilt Yes
to Zoom
Audible Noise <66 dB
Electrical
Camera
Input Voltage 18 VAC nominal
Power Consumption 18 W maximum
Current Consumption 1 A maximum
0 lux 0 lux
0.066 lux 0.166 lux
0.0026 0.0082 lux
lux
IR Illuminator
26 VDC nominal
26 W maximum
1 A maximum
Miscellaneous
Sectors / Titling 16 independent sectors with 20-character titles/
sector
Privacy Masking 24 individually configurable privacy masks
Pre-positions 99, each with 20-character titles
Camera Setup / RS-485, Bilinx (coax)
Control
Communications Bosch (OSRD, Bilinx), Pelco P/ D, Forward Vision
Protocols (Bosch OSRD requires use of converter device
(MIC-BP3, sold separately.))
Guard Tours Two (2) types of tours:
• Recorded tours - two (2), total duration
15 minutes
• Preset tour - one (1), consisting of up to
99 scenes, consecutively and (1)
customized up to 99 scenes
Window Wiper Standard
Washer Drive Optional washer kit (MIC-WKT Kit used with the
appropriate HAC-WAS washer pump)
Supported English, Czech*, Dutch, French, German, Italian,
Languages Polish, Portuguese, Russian*, and Spanish
* Available with separate language upload
User Connections
Power, Camera Via composite cable (sold separately)
Power, IR Illuminator Via composite cable (sold separately)
Control Data RS-485 (Twisted pair; Simplex, half and full
duplex operation via composite cable)
Biphase ±
(Optional; requires MIC Biphase module with
external power supply.)
Video Coaxial via composite cable (sold separately)
Alarm Inputs Four (4) tamper inputs
Relay Outputs Two (2) relay outputs and washer relay
output only with optional alarm card
Alarm Tamper switch (ground connection)
Communication
Software CTFID software allows direct connection to a
USB-equipped PC via the MIC Series PSU
over a full du-plex to provide access to all
camera functions and useful diagnostic tools.
Environmental
Ingress Protection IP68
Rating
Operating -40 °C to +60 °C (-40 °F to +140 °F)
Temperature
Cold Start-up -40 °C (-40 °F)
Temperature (Requires 30-minute warm-up prior to PTZ
operations)