Operating Instructions; Key Pad Features - Danby DAC 8007EE Owner's Use And Care Manual

KEY PAD FEATURES

LED DISPLAY: Displays the following
information independently;Set Temperature,
Ambient RoomTemperature and Auto Timer
On/Off settings.
POWER: Turns unit On/Off.
MODE: Allows you to scroll through and
select the desired operating mode; Cool , Dry ,
Fan Only and *Auto .The selected mode will be
denoted by the adjacent indicator light.*'Auto'is a
pre-set factory program that automatically
defines the mode (Cool or Dry) and fan speed
based on the set temperature.
FAN SPEED: Select from four different fan
settings;Low , Medium , High and Auto during
Cool and Fan Only mode. Please note: During
'Dry' mode the fan speed is automatically
defined .
ENERGY SAVER: Automatically cycles the
fan on and off while the compressor is not in
use.
TEMP / TIMER CONTROL: Used to
increase or decrease the Temperature setting in
1°C / °F increments, and Auto-Timer On/Off
settings in 30min./1hr. increments.
Note:This appliance allows you select the
temperature scale to be displayed in either
"Celsius" or Fahrenheit" according to your
preference.To change the temperature scale
displayed on the electronic display, press both
the "Temp/Timer"adjust arrows simultaneously to
alternate between "Celsius"&"Fahrenheit".
CHECK FILTER: The adjacent indicator light
will illuminate as a reminder to clean the air
conditioner filter (see page 9) Once the filter
has been cleaned and replaced, depress the
Check Filter button in order to resume operation.
SLEEP MODE: When activated, the current
set temperature is gradually increased over a
one (1) hour period then maintained for seven
(7) hours. Once the program is complete, the air
conditioner will resume to its previous set
temperature (before sleep mode was
activated). This feature is mean to be used
during the night time hours to prevent the room
from getting too cold (while you sleep) and
results in less compressor running time and
reduced energy consumption. Sleep mode may
be cancelled by depressing the Sleep Mode
button while the program is running.

OPERATING INSTRUCTIONS

Temp/Timer
Control
Check
Filter
Mode
Selector
Energy
Saver
AUTO-TIMER: Used to initiate the Auto
On/ Auto Off timer.
While the Air Conditioner is off (Auto-
On):
1) Press the Auto-Timer button once and the
adjacent Auto-On indicator light will
illuminate.
2) Use the Temp/Timer control cursors to
select adelayed Ontime of up to 24 hours.
3) Select the appropriate mode under which
you want the unit to operate (Auto-Cool-Dry-
Fan Only)
4) Select the fan speed setting.
5) The time you selected will appear in the
LED display.
While the Air Conditioner is on (Auto-
Off):
1) Press the Auto-Timer button twice and
the adjacent Auto-Off indicator light will
illuminate.
2) Use the Temp/Timer control cursors to
select a delayed Off time of up to 24 hours.
3) The time you selected will appear in the
LED displayThe Auto On and Auto Off timer
can operate during the same program by
defining the Auto-Off parameters
immediately after the Auto On parameters.
The Auto-Timer may be cancelled at any
time by turning the unit On/Off.
7
LED
DISPLAY
Auto
Timer
Sleep
Mode
Fan
Speed
Power
Button