Operating Instructions - Danby dac060eb3gdb Owner's Use And Care Manual

Operating Instructions

KEY PAD FEATURES
TEMP/ TIMER
CONTROL
CHECK
FILTER
MODE
SELECTOR
ENERGY
SAVER
LED DISPLAY: Displays the following information independently - Set
Temperature, Ambient RoomTemperature and Auto Timer On/Off settings.
POWER: Turns unit On/Off.
NOTE: The unit will automatically launch the Energy Saver function when it is
in Cool, Dry, and Auto modes.
MODE: Allows you to scroll through and select the desired operating
mode: Cool , *Dry , Fan Only and **Auto. The selected mode will be denot-
ed by the adjacent indicator light.
Note on **Auto operation:
Auto is a pre-set factory program that automatically defines the mode and
the fan speed, based on the set temperature you have chosen. An example
of Auto operation is as follows.
If you would like to cool down your room, your desired/ set temperature will
be below the room temperature, and your air conditioner will go into cooling
mode. Once the room has reached your desired temperature, the air condi-
tioner will switch to Fan mode, and circulate the cooled air around the room.
When the temperature in the room goes up, the unit will switch back to
cooling mode, and the Auto cycle will start again.
Note on *Dry operation:
Please note that in this mode you cannot set the desired humidity level, it is
automatically pre-set. The fan speed in this setting is defaulted to "low", but
since the compressor is operating in order to remove moisture from the air,
you will experience a degree of cooling as a by-product.
LED
DISPLAY
FAN SPEED: Select from four different fan settings: Low , Medium,
High and Auto during Cool and Fan Only mode. Please note, during 'Dry'
mode the fan speed is automatically defined.
ENERGY SAVER: This is the default setting on this model. The unit
will automatically cycle the fan on and off while the compressor is not in use.
The fan will continue to run for 3 minutes after the compressor shuts off. The
fan then cycles on for 2 minutes at 10 minute intervals, until the room tempe-
AUTO
rature is above the set temperature. At this point, the compressor turns back
TIMER
on and cooling re-starts. When the unit is in Energy Saver mode, the indicator
light above the Energy Saver button will be illuminated. You can take the unit
out of Energy Saver mode by pressing the Energy Saver button – the indicator
light above the button will turn off. If you choose the non-Energy Saver option,
the fan will run continuously when the compressor is not in use.
SLEEP
MODE
TEMP / TIMER CONTROL: Used to increase or decrease
the Temperature setting in 1°C / °F increments, and Auto-Timer On/Off set-
tings in 30min./1hr. increments. Note: This appliance allows you select the
temperature scale to be displayed in either "Celsius" or "Fahrenheit"
according to your preference.To change the temperature scale displayed
on the electronic display, press both the "Temp/Timer"adjust arrows simul-
FAN
taneously to alternate between "Celsius" & "Fahrenheit".
SPEED
CHECK FILTER: The adjacent indicator light will illuminate as a
reminder to clean the air conditioner filter (see page
POWER
been cleaned and replaced, depress the Check Filter button in order to
BUTTON
resume operation.
SLEEP MODE:
(when in cooling mode) by 2 °F one half-hour after Sleep mode has been
selected. The temperature will then increase by another 2 °F after an addi-
tional half hour. This new temperature will be maintained for 6 hours before
returning to the originally selected temperature. This ends the Sleep mode
and the unit will continue to operate as originally programmed. The Sleep
mode program can be cancelled at any time during operation by pressing the
Sleep button again.
7
In this mode, the selected temperature will increase
11). Once the filter has