Energy Saving Tips; Installation - Danby DAC 8007EE Owner's Use And Care Manual

IMPORTANT SAFETY INFORMATION
ENERGY-
SAVING TIPS
1) Select a thermostat setting that suits your
comfort needs and leave at that chosen
setting.
2) The filter is very efficient in removing
airborne particles. Keep the air filter clean.
Normally, filters should be cleaned every 2
weeks. More frequent cleaning may be
necessary depending on indoor air quality.
3) Use drapes, curtains or shades to keep
direct sunlight from penetrating and heating
room, but do not allow drapes or curtains to
obstruct the air flow around the unit.
ELECTRIC SHOCK HAZARD: To avoid the possibility of personal injury, disconnect power to
the unit before installing or servicing.
TOOLS NEEDED FOR INSTALLATION:
Screw Drivers: Both Phillips and flat head
Power Drill: 1/8 inch (3.2mm) diameter drill bit
Pencil
Measuring Tape
Your Room Air Conditioner is designed for easy
installtion in a single or double-hung window. This unit
is NOT designed for vertical (slider type) windows
and/or through-the-wall applications.
NOTE: Save the shipping carton and packing materials
for future storage or transport of the unit. From carton,
remove the plastic bag containing the installation
hardware kit necessary for the installation of your air
conditioner. Please check the contents of hardware kit
against the corresponding model check list, prior to
installation of the unit. See Fig. 1.
CAUTION: Because the compressor is located on
the controls side of the unit (left side), this side will be
heavier and more awkward to manipulate. Inadequate
support on control side of the unit can result in personal
injury and damage to your unit and property. Therefore, it
is recommended that you have someone assist you during
the installation of this unit.
NOTE: Your unit is designed to evaporate condensation under normal conditions.
However, under extreme humidity conditions, excess condensation may cause basepan
to overflow to the outside. The unit should be installed where condensation run-off
cannot drip on pedestrains or neighboring properties
Your Danby appliance is designed to be highly efficient in energy
savings. Follow these recommendations for greater efficiency.

INSTALLATION

Scissors
Carpenters Level
4) Start your air conditioner before the
outdoor air becomes hot and uncomfortable, to
avoid an initial period of discomfort while the
unit is cooling off the room.
5) When outdoor temperatures are cool
enough, use HIGH or LOW FAN only. This
circulates indoor air, providing some cooling
comfort, and utilizes less electricity than when
operating on a cooling setting.
INSTALLATION HARDWARE
3/4" (19.1mm)
screws (9)
3/8" (9.5mm) screws
(4) (*Factory
installed on some
models)
Adhesive
Foam Seal(1)
Fig. 1
4
Safety Lock (1)
"L" Shaped
mounting
bracket (1)
*Factory installed
on some models
Sash bracket (2)
Side Curtain RH (1)
Side Curtain LH (1)