NAPCO Gemini GEM-P1632 Installation Instructions Manual page 19

WI808F 8/03
New
Compat #
Press the button to continue or press the
R
EZM Address
Workbook) similar to its keypad address. If no other EZMs are to be used, designate the keypad as Group "01" at the
EZM ADDRESS 00
" " display. In multiple-EZM systems, enter an assigned group number "01" through "06". (Each EZM
must have a unique assigned group number, starting with "01" and proceeding consecutively.) Press the
save. Press the button to continue or press the
R
Zone Response
zone(s) to be changed:
Zone 1=(1); Zone 2=(2); Zone 3=(4); Zone 4=(8)
2. Add up the circled numbers.
3. At the keypad, enter the sum as a two-digit number "01" through "15" on the display, then press the
Example. Change Zones 2, 3 and 4 to 50mS response.
1. Circle numbers for Zones 2, 3 and 4: (2), (4) and (8).
2. Add up the circled numbers: 2 + 4 + 8 = 14.
3. Enter "14" at the keypad, then press the
Press the button to continue or press the
R
Program Control
Message #
selections, for changes) or press the
SYSTEM
"). Then replace Jumper JP1 across Pins 1–2 (top two).
L
NAPCO Security Systems
Compatibility Number (Not Applicable)
THIS FEATURE IS NOT COMPATIBLE WITH THE GEM-P1632
0000
CONTROL PANEL.
button to exit.
C
EZM Address
The keypad's internal EZM (Expansion Zone Module) may be utilized to
01
provide four additional wired zones. Whether used alone or in conjunction
with optional GEM-EZM series modules or other keypad EZMs, it must be
assigned a unique address (or Group number, see Keypad Programming
C
Zone Response
The normal loop response of each keypad expansion zone is 750mS,
00
however the response time of any zone can be reduced to 50mS as
follows.
1. Of the following, circle the number(s) in parentheses associated with the
U
button.
button to exit.
C
Program Control Message (Not Applicable)
THIS FEATURE IS NOT COMPATIBLE WITH THE GEM-P1632
CONTROL PANEL.
?
Press the
R
button to exit the Keypad Configuration Mode (display will read "
C
button to exit.
button to continue (the display will loop back through
X
GEM-P1632 Installation Instructions
!
Page 19
U
button to
U
button.
01 OUT OF