ProForm 1150ci User Manual page 5

1. Identify the Front Stabiliser (2), which has Wheels (30)
on the ends. Whilst another person lifts the front of the
Frame (1) slightly, attach the Front Stabiliser to the
Frame with two M10 x 112mm Carriage Bolts (65) and
two M10 Black Nylon Locknuts (63). Make sure that
the Front Stabiliser is turned so the Wheels are not
touching the floor.
2. Whilst another person lifts the back of the Frame (1)
slightly, attach the Rear Stabiliser (3) to the Frame with
two M10 x 112mm Carriage Bolts (65) and two M10
Black Nylon Locknuts (63).
3. Whilst another person holds the Upright (13) in the
position shown, connect the Upper Wire Harness (36)
to the Lower Wire Harness (35). Carefully pull the
upper end of the Upper Wire Harness to remove
any slack from the Wire Harnesses; make sure that
the connectors do not catch on the indicated rod.
Turn the indicated Adjustment Knob (28) counterclock-
wise two or three turns to loosen it. Next, pull the Knob,
insert the Upright (13) into the Frame (1), and then
release the Knob. Be careful to avoid pinching the
Wire Harnesses (35, 36). Move the Upright up and
down slightly until the pin on the Knob snaps into
one of the holes in the Upright. Then, turn the Knob
clockwise until it is tight.
Tighten the M6 x 25.4mm Button Screw (33) into the
Frame (1) and into the slot in the side of the Upright
(13).
4. The Console (16) requires four 1.5V "D" batteries;
alkaline batteries are recommended. Press the tab on
the battery cover, and lift off the battery cover. Insert
four batteries into the battery compartment. Make sure
that the batteries are oriented as shown by the
markings inside the battery compartment. Reattach
the battery cover.
1
65
30
2
63
1
3
13
Slot
36
35
33
4
Battery
Cover
Batteries
5
30
2
1
63
63
3
65
Avoid
pinching
the Wire
Harnesses
Rod (35, 36).
1
28
Tab
16