Maintenance And Troubleshooting - ProForm 115 Csx Bike User Manual

MAINTENANCE AND TROUBLESHOOTING

Inspect and tighten all parts of the exercise bike regu-
larly. Replace any worn parts immediately.
To clean the exercise bike, use a damp cloth and a
small amount of mild soap. IMPORTANT: To avoid
damage to the console, keep liquids away from
the console and keep the console out of direct
sunlight.
CONSOLE TROUBLESHOOTING
If the console display becomes dim, see assembly step
9 on page 10 for battery replacement instructions.
If the console does not display your heart rate when
you use the handgrip heart rate monitor, see step 5 on
page 16.
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the
reed switch should be adjusted.
To adjust the reed switch, you must remove the seat
post, the adjustment knob, and the top shield (see the
instructions below).
To remove the Seat Post (5), loosen the Adjustment
Knob (11) a few turns, pull the Adjustment Knob
outward, and remove the Seat Post. Then, using an
adjustable wrench, remove the Adjustment Knob.
5
Using a flat screwdriver, release the tabs along the bot-
tom edge of the Top Shield (9) and slide the Top Shield
upward.
9
11
Locate the Reed Switch (21). Turn the Pulley (13) until
a Pulley Magnet (16) is aligned with the Reed Switch.
Loosen, but do not remove, the indicated M4 x 16mm
Screw (40). Slide the Reed Switch slightly closer to or
away from the Magnet, and then retighten the Screw.
Turn the Pulley (13) for a moment. If necessary, repeat
the step above until the console displays correct
feedback.
When the reed switch is correctly adjusted, reattach
the shield cover, the adjustment knob, and the seat
post.
HOW TO LEVEL THE EXERCISE BIKE
If the exercise
bike rocks
slightly on your
floor during use,
turn one or both
of the leveling
feet until the
exercise bike is
level.
19
13
16
21
40
Leveling
Feet