ProForm 115 Csx Bike User Manual page 10

8. Identify the Right Handlebar (48), which is
marked with an "R" sticker, and orient it as
shown. Make sure that the hexagonal holes
are in the indicated location.
While a second person holds the Right
Handlebar (48) near the Upright (3), tie the indi-
cated wire tie to the Right Pulse Wire (42). Then,
pull the other end of the wire tie upward out of
the top of the Upright.
Tip: Avoid pinching the wire. Slide the Right
Handlebar (48) onto the Upright (3).
Attach the Right Handlebar (48) with two M8
x 38mm Bolts (53) and two M8 Locknuts (37).
Make sure that the Locknuts are in the hex-
agonal holes.
Attach the Left Handlebar (47) in the same
way.
9. The Console (6) can use four D batteries (not
included); alkaline batteries are recommended.
Do not use old and new batteries together or
alkaline, standard, and rechargeable batter-
ies together. IMPORTANT: If the Console has
been exposed to cold temperatures, allow
it to warm to room temperature before you
insert batteries. Otherwise, you may dam-
age the console displays or other electronic
components. Remove the screws and the
battery covers, insert batteries into the battery
compartments, and then reattach the battery
covers. Make sure to orient the batteries as
shown by the diagrams inside the battery
compartments.
To purchase an optional power adapter, call
the telephone number on the front cover of
this manual. To avoid damaging the console,
use only a manufacturer-supplied power
adapter. Plug one end of the power adapter into
the receptacle on the console; plug the other
end into an outlet installed in accordance with all
local codes and ordinances.
8
47
3
9
Screws
Batteries
6
10
Avoid pinching
the wire
28
Wire Tie
53
42
37
Hexagonal
Holes
Battery
Covers
Batteries
48